When drain lines in your home become clogged, wastewater can’t move from the low-lying plumbing fixtures to the sewer line as it should. This eventually causes water to overflow into the basement floor drain.If you notice that your basement floor drain is constantly backed up, it’s probably time to call in a plumber. The plumber will be able to find the root of the problem and get it fixed before it becomes too severe.A floor drain pop-up is a type of floor drain that uses a compression spring to make the cover of the drain pop up. It also has a drain basket that filters hair and debris to prevent drain clogs.These drains can be made from brass or stainless steel, depending on your preference. The latter is durable and corrosion-resistant, so it can withstand the harsh environment of a bathroom.

They are available in many styles, ranging from classic to contemporary. They are appropriate for any type of sink, including vessel sinks and drop-in sinks.They must be installed at a downhill angle, preferably 2’’ inches lower than the drain inlet, which is usually where your downspout comes out. This ensures that water can flow through your lawn and downhill away from your home.A floor drain pop-up is a pretty neat piece of plumbing hardware. The best part is that it's not hard to install if you have the right tools and the right know-how.First, take a good look at the pipes. You'll probably have to re-plumb your sink and bathroom to make it all fit, but if you have the patience, you can do it yourself in no time.Next, measure the hole with a tape measure to make sure it's the same size as the one in your shower. You'll also want to mark the hole a few inches off center.

It's a good idea to use white cement to coat the hole as this will help prevent any clogs from forming. This will also allow you to see where the pipe is positioned for future plumbing work. The best part is, you'll be able to use the same material for any future plumbing jobs as long as you keep it sealed from the elements.Pop-up drains need to be adjusted periodically in order to keep them functioning properly. If they don't pop up and down the way they should, it may be because one of the components is out of whack or has worn down. It is also important to check the pivot rod for hair and other obstructions that can cause clogs. If there is a problem with the seal on the pivot rod, you will need to replace it.

To adjust a pop-up drain, use a basin wrench to loosen the stopper nut. You should be able to remove the pop-up assembly from the sink without damaging it, so long as you don't drop it or use too much force. Once the nut is free, you can remove the spring clip and clevis strap from the pivot rod. After that, clean the pivot rod with a bent wire hanger to remove any hair and other blockages that may have built up.